6.8SPC Upper

Can anyone tell me where I can find a stripped upper and parts for 6.8SPC. I can find a complete upper all day long. The point of building a rifle is to actually put the parts together myself. Any help would be greatly appreaciated guys.

The only parts different for the 6.8 SPC vs a 556 is the barrel and the bolt. Other than that, it’s all the same.

For barrels you might try WOA. For bolts, I would recommend LMT.

Probably stating the obvious here but the mag’s are also different.

+1 barrels WOA and bolt LMT

Magazines PRI or Barrett

So the bolt carrier is the same as 5.56 too? If that’s the case, then I can get a barrel and a headspaced bolt to match from WOA.

Yes, the bolt carrier is the same…and yes, you will need dedicated 6.8 magazines unless all you need is 4-5 rounds at a time. A 556 magazine will be able to hold and feed 4 or 5 rounds of 6.8 but that’s about all. Any more than that the mag sides will start to bulge.:wink:

As posted, the upper (less barrel) and carrier are the same. That is, in fact, the whole reason that some of these companies sell just the barrel and bolt. That, and magazines, are all you need to change to 6.8 in a 5.56 AR.

Stag has been shipping bolts pretty quickly even though they say “out of stock” on their site, and in fact I think I now have a complete BCG on the way too that I ordered a few months ago since I just got a shipping notification and can’t think of anything else I would have ordered from them.

The muzzle device is also typically different. Most 6.8 barrels are threaded 5/8x24, which is also the standard threading for .308 barrels. There are other odd thread patterns around like 1/2x36 (Stag), so you’ll have to check with the barrel mfg to be absolutely sure.

Good point Capo. I ran into this too. it does appear that most are settling on the .308 standard, and the comparison chart on 68forums has a spot for the thread pitch, IIRC.

I just picked up a WOA 16" barrel and Larue Billet upper. I’m going for Larue free float handguard and low profile gas block. I pose these questions.

Can I use a standard low profile 5.56 gas block on a 6.8 barrel? How long of gas tube on a 16" barrel? Anyone with the Larue freefloat handguard, do I still need the barrel nut/any other parts or is everything included?

First upper build, sorry for the Hijack.

I’ve had no problems with CMT full auto BCG in my 10.5". I’ll likely go with CMT or LMT auto carrier carrier and PRI charging handle.

Yes, you can use any 5.56 gas block that fits the barrel’s gas block journal. The WOA uses any standard 0.750" gas block.

The WOA 16" barrel uses a midlength gas tube.

The Larue handguard comes with everything you need to mount it up, including a barrel nut. You don’t need a standard AR barrel nut or delta ring assembly.

Awesome! That, BCG and charging handle and some irons and should be good to hook yeah? I appreciate the fast response.

This is good news.
I’ve been thinking about a 6.8 for awhile now. Bolt, barrel, brake, and mags are the only difference, sweet!