USMC03
08-08-06, 07:51
I recently had Jason at www.jtacsupply.com finish up my last AR15 project.
I wanted something that I could use in our local monthly rifle matches where stages are set up with paper and steel targets at unknown distances from 1 yard out to 450 yards. And something that could be used in 3 gun competition.
I started this project back in early May and due to some problems with Rock River Arms, I got the lower receiver back a couple weeks ago.
This gun is light and very well balanced and "swings" well.
With the rifle length gas system and the MSTN QC comp the felt recoil and muzzle flip are next to nothing. In a the prone position using the magazine as a mono-pod, I don't loose my sight picture at 450 yards when shooting steel gongs with the Leupold MR/T M2 on 5x.
Communications with Jason were great and turn around was fast. Jason was more than helpful with this project (answering questions, etc). Thanks again Brother!!!
-Rock River Arms factory upper, A2 lower, bolt carrier, and charging handle
-White Oak Armament 18" SPR barrel with rifle length gas system
-LaRue Tactical low profile gas block
-MSTN QC Comp
-PRI Gen III rifle length fore end
-Troy Ind front and rear BUIS
-LaRue Tactical SPR 1.5 mount
-Leupold MR/T 1.5-5x20 M2 w/ SPR reticle
-Falcon Ind rubber ERGO grip
-Magpul Enhanced Trigger Guard and Ranger Plate
http://www.coloradoshooting.org/usmc03%20gamer1.jpg
http://www.coloradoshooting.org/usmc03%20gamer2.jpg
http://www.coloradoshooting.org/usmc03%20gamer3.jpg
http://www.coloradoshooting.org/usmc03%20gamer4.jpg
I wanted something that I could use in our local monthly rifle matches where stages are set up with paper and steel targets at unknown distances from 1 yard out to 450 yards. And something that could be used in 3 gun competition.
I started this project back in early May and due to some problems with Rock River Arms, I got the lower receiver back a couple weeks ago.
This gun is light and very well balanced and "swings" well.
With the rifle length gas system and the MSTN QC comp the felt recoil and muzzle flip are next to nothing. In a the prone position using the magazine as a mono-pod, I don't loose my sight picture at 450 yards when shooting steel gongs with the Leupold MR/T M2 on 5x.
Communications with Jason were great and turn around was fast. Jason was more than helpful with this project (answering questions, etc). Thanks again Brother!!!
-Rock River Arms factory upper, A2 lower, bolt carrier, and charging handle
-White Oak Armament 18" SPR barrel with rifle length gas system
-LaRue Tactical low profile gas block
-MSTN QC Comp
-PRI Gen III rifle length fore end
-Troy Ind front and rear BUIS
-LaRue Tactical SPR 1.5 mount
-Leupold MR/T 1.5-5x20 M2 w/ SPR reticle
-Falcon Ind rubber ERGO grip
-Magpul Enhanced Trigger Guard and Ranger Plate
http://www.coloradoshooting.org/usmc03%20gamer1.jpg
http://www.coloradoshooting.org/usmc03%20gamer2.jpg
http://www.coloradoshooting.org/usmc03%20gamer3.jpg
http://www.coloradoshooting.org/usmc03%20gamer4.jpg