Tell your gunsmith to make your extractor look like mine in the pic. Also tension it properly.
Not a super expensive job. Probably $50 ish
Those guns are not assembled by gunsmiths. The extractors need some attention.
Tell your gunsmith to make your extractor look like mine in the pic. Also tension it properly.
Not a super expensive job. Probably $50 ish
Those guns are not assembled by gunsmiths. The extractors need some attention.
Here's something that you don't see every day. Fitting a 9mm extractor using the same method as fitting a .45 extractor. It takes more time and effort but yields great results. I do mine this way and know a few others who do also.
https://www.1911addicts.com/threads/...t#post-3329387
Here's another post that touches on the subject of fitting minor caliber extractors using the same .45 method.
https://www.1911forum.com/threads/tu...#post-13924410
Well I tried the gun today with the tensioned extractor. Fired 50 rounds and had 1 failure to extract.
So I bought a Wilson Combat Bullet Proof extractor. Should be here Sunday.
C co 1/30th Infantry Regiment
3rd Brigade 3rd Infantry Division
2002-2006
OIF 1 and 3
IraqGunz:
No dude is going to get shot in the chest at 300 yards and look down and say "What is that, a 3 MOA group?"
Hey Tirib! I drop in here once in a while.
Go to this LINK to read all about fitting an external 1911 extractor correctly. There's more to it than simply dropping one into the slide. Tension is just one of the three basic areas that need to be addressed when fitting an extractor and is last on the list to be addressed. The other two are geometry and deflection.
FWIW, I prefer EGW extractors for two reasons. One is that they're shorter than the others which means there's less work during fitting. Two is that they have extra "meat" in all the right places to allow custom fitting to every slide that's ever come across my bench. Good luck with the Wilson extractor.
Fitting a 9mm extractor so that the edge of the hook pushes against the flat immediately ahead of the case rim is the most common, fastest, and easiest method which makes it a favorite of 'smiths. But, in my experience, it's not the best method as I touched on in post #12. Ask your 'smith about it and watch him scratch his head.
This post may be of some interest.
C 1/66 Armor - A 2/67 Armor - CSC 2/67 Armor - HQ 2/67 Armor
Cold War 70s and 80s
Finally some good news.
With the Wilson extractor ordered I decided to just crank on the extractor. I've been fairly gentle with it since I didn't want to over do it. Well apparently I just needed to use my man hands and put some torque on it.
Shot 100 rounds today with total reliability. Then I did the 10-8 extractor test for 20 rounds. It fully extracted all rounds. 3 of them did fly back at 6 o'clock, which isn't ideal, but it functions now.
C co 1/30th Infantry Regiment
3rd Brigade 3rd Infantry Division
2002-2006
OIF 1 and 3
IraqGunz:
No dude is going to get shot in the chest at 300 yards and look down and say "What is that, a 3 MOA group?"
Bookmarks