I have ALL KINDS of stuff I'll gladly throw into the pot..:
I'll start w/:
*GONE*.) A-2 Birdcage Flash Supp., std. 1/2"x28 thread.
*GONE*.) Set Std. "Bushy" Carbine Fore Ends (Hand Guards), w/ heat shield.
3.) Set Adams Arms Oval Carbine Fore Ends (Hand Guards); NOT heat shielded.
4.) 7.62x39, Slant Cut, Std. AK Muzzle Brake, 14mm, RH thread. (Yugo. AK Take-Off)
*GONE*.) G-23, Full Cap. Factory Mag. (Got rid of the Glock...)
gunfixer@live.com
E!
I could use some .154, KNS Anti-Rotat. pins... (GA.)
Last edited by erh; 10-25-08 at 08:41.
-E!-
New member here, but think this thread is a wonderful idea.
I'm throwing 100 count Mixed headstamp once-fired 9mm brass in the mix. NOT fired from a Glock, so no guppy cases.
Oh, and I'll take those Bushy handguards as well..
I have an ambidextrous AR receiver end plate for slings with HK style hooks if anyone needs it. Only one previous stake mark in it. I just took it off my rifle this morning to change to QD mounts. No name on it and I don't recall the brand.
(ETA- Gone to taarobaap)
Last edited by Azrael2004; 10-18-08 at 18:01. Reason: Updated as taken
To have a right to do a thing is not at all the same as to be right in doing it. - GK Chesterton
FS: Springfield XD9 custom two tone...check it out:
http://www.ar15.com/forums/topic.html?b=7&f=88&t=590004
Looking for a receiver end plate for sling mount that will work with my A2 stock. Also some belt mounted ar mag pouches.
Semper Paratus
(Always Prepared)
Bookmarks