Who can do a URX 3 install for me?

[Robb Jensen]

Try Robb at VA Arms. He did mine for a very reasonable cost.

That's correct I have the KAC URX wrench, the URX II/III wrench, the SR25 URX wrench and the KAC alignment block for correct assembly of their rails.

[bp7178]

I'm looking to have a Surefire MB556 pinned & welded, Noveske barrel Cerakoted/gun koted flat black, all installed with a URX-II rail.

What kind of turn around time do you have Robb?

[AR15barrels]

Randall, what are your wait times like these days?

Usually a couple weeks.
Don't send anything for then next month or so though as I'm getting ready to tear down my shop and move it to a new location.
It's gonna be mayhem for a little bit...

[mtdawg169]

That's correct I have the KAC URX wrench, the URX II/III wrench, the SR25 URX wrench and the KAC alignment block for correct assembly of their rails.

Can't say enough good things about Robb! He did an awesome job on my URX install and Norrell's moly coat.






Sent from my DROID RAZR using Tapatalk 2

[saddlerocker]

Can a FSB be shaved to fit under the URX II Mid, or is a low pro gas block needed?

[KevinB]

Anything can be shaved

I've done Shaved FSGB on the middies -- some creative times with an end mill and then belt sander.

I dremeled one as well on a personal gun a while back.

[mtdawg169]

Anything can be shaved

So many smart ass remarks running through my head right now! ;-)

Saddlerocker, yes you can fit a shaved fsb under the mid urx. Gun Gallery has done several carbine length builds that way. A midlength might be a little bit trickier since it would sit under the front sight assembly.

Sent from my DROID RAZR using Tapatalk 2

[AR15barrels]

A midlength might be a little bit trickier since it would sit under the front sight assembly.

Yeah, fitting a gas block right under the front sight on a URX is tricky because there is less clearance there.
I seem to remember having to mill down even a very low profile gas block a little bit...

[mtdawg169]

Yeah, fitting a gas block right under the front sight on a URX is tricky because there is less clearance there.
I seem to remember having to mill down even a very low profile gas block a little bit...

Pretty common for midlength gas, usually on the leading edge of the top of the GB. The URX design was changed to give additional clearance, so it really depends on the gas block being used.

Sent from my DROID RAZR using Tapatalk 2