bolt, ejector tool
FF, rail alignment tool
DPMS M4 castle nut wrench.
DPMS AR10/SR25 barrel wrench for installing/removing AR10/SR25/DPMS (.308) rails/bbl nuts
A2 rear sight tool
M4 stock tool
upper receiver block
other upper and lower receiver blocks I rarely use this type of upper block because it leaves marks on upper receivers
strap wrench
free float wrench rarely used but sometimes the only way to remove some FF tubes and not damaging them
coated barrel vice blocks perfect for changing flash hiders without twisting the barrel within the action, it doesn't leave marks on the barrel like aluminum blocks, I have 2 sets one stock set (works for 20-24" rifle bbls and 16" M4 bbls) and I had a set cut in half (works on mid-length 16" and 14.5" bbls in a 6" vise)
handguard tool makes removing/installing plastic handguards easy by yourself
various tools I recommend buying the FSB bench block, bbl nut alignment gauge, firing pin protrusion gauge, 5.56mm NATO FIELD headspace gauge, and a complete set of roll pin starters and roll pin punches and a small brass hammer, taper pin punch & USGI bbl wrench
Bookmarks