Those leg shrouds are extremely adaptable; consider just putting holes in the shroud to match your holster, where you need them to be....
Take a piece of paper, lay it across the back of the holster, use a marker to mark the paper (or punch holes in the paper) where the female-threaded hardware is on the holster back, transfer that pattern to wherever height you want to use on the leg shroud, use a soldering iron to make holes in the shroud, mount the holster with the usual hardware.
I've only ever used the 3-hole pattern; is the 2-hole vertical or horizontal? I'm guessing vertical, like the two holes within the 3-hole pattern on the QLS plate shown, but don't know.
QLS and calipers are at home, will see what's what later, if nobody else can get to theirs.
Contractor scum, New & Legacy Equipment Trainer
PM Infantry Weapons, USMC
Bookmarks