Noveske Rifleworks Lowers

[xm15]

I picked mine up and I am suprised at the quality. I wanted a nice one but this is better than I expected.
the finish could not be better, the color the machining the fit. I put the MUR on it and it is TIGHT! just like I wanted. the buffer tube it came with is also comparable in quality/finish. well staked, H buffer, 6 position and "seems" to have more meat to it (have not actually measured it).
the rollmarks are done nicely, not mashed in or light. a good even depth.

Noveske has done a very good job on this assembly, mine was a partiallly complete lower I got from their website. and the vendor they use now was a good choice to go with..

if anyone wants to see I will post a few pics after I get some tonight.
worth the $$ I like!

Now I just need to put in an order for a barrel from them and an American Infidel will be born!

their trade marked "Stops Jihad on contact" is right on.

Thanks Noveske

[C4IGrant]

I picked mine up and I am suprised at the quality. I wanted a nice one but this is better than I expected.
the finish could not be better, the color the machining the fit. I put the MUR on it and it is TIGHT! just like I wanted. the buffer tube it came with is also comparable in quality/finish. well staked, H buffer, 6 position and "seems" to have more meat to it (have not actually measured it).
the rollmarks are done nicely, not mashed in or light. a good even depth.

Noveske has done a very good job on this assembly, mine was a partiallly complete lower I got from their website. and the vendor they use now was a good choice to go with..

if anyone wants to see I will post a few pics after I get some tonight.
worth the $$ I like!

Now I just need to put in an order for a barrel from them and an American Infidel will be born!

their trade marked "Stops Jihad on contact" is right on.

Thanks Noveske

They are some of the nicest forged lowers I have seen.


C4

[xm15]

the rear pin had to be tapped in, it was VERY tight








was going to try it today but constant heavy rain so tomorrow may be the time

the only problem with this build is the rear take down pin and the ejection port door will not close unless tapped with a SOFT rubber mallet.the machining is a bit close. the parts are fine just tight tolerances I guess.

[C4IGrant]

Very nice!


C4

[SuicideHz]

My Noveske/MUR needs a punch for removing the rear takedown pin still. It's ridiculously tight but that's better than wobbly I guess!

[jackinfl]

Which Hammer and trigger parts are you guys putting in these lowers. More directly who's trigger hammer parts is COLT using?
Thanks in advance.

[EmanP]

I ordered mine direct from CMT/Stag. Only problem is they have a minimum order of $50 and it's only $35 worth of parts so you may as well stock up on spare parts.

[C4IGrant]

Which Hammer and trigger parts are you guys putting in these lowers. More directly who's trigger hammer parts is COLT using?
Thanks in advance.

I have been using CMT LPK's in the ones that I have built.


C4