So I just installed a SiCo tri-lug connector on my Octane 45 for use on some PCC SBRs and the fit from the connector to the tri lug adapter on the barrel is super loose. The can wiggles around enough that I'm afraid to use it with my Scorpion EVO and AR9s. I put my Griffin Armament tri lug connector on my SiCo Octane and the fit is nice and tight with very little wiggle on the can. Has anyone else noticed the loose fit of the SiCo tri lug connector to tri lug adapter? I think I'm going to order another Griffin tri lug connector and sell the SiCo one the wobble is horrendous.
Also I was using a CNCWarrior?? 9mm Bore alignment rod to check for alignment and the wobble was so bad the rod could touch the edge of the 45 end cap. Is this something SiCo would replace or is it normal?
Reply With Quote
Bookmarks