Ok, got a new SF LED forearm for my work Remington 870. For the life of me, I can't get that nut on the forearm/action bar assembly where the slots line up in a horizontal position when tightened down (horizontal position when looking straight down the business end into the forearm over the magazine tube), as recommended. You guys have any tips for this? I saw Brownells has a T-wrench tool for the forearm nut, but I didn't want to spend $50 on a tool, I was using the wrench supplied from SureFire.
Also, a few colleagues recommended a drop of blue locktite on the threads or a strip of teflon tape (plumbers tape) around the threads because the heavier SF forearms tend to vibrate the nut loose over time in vehicle racks. Any thoughts/ideas? Thanks for the assist!
Bookmarks