Visual guide: How to fill out a Form 1 using EFORMS

[skt4271]

i didnt put my trust name at all, i didnt know thats where it goes. i also didnt put anything for unit of measurement. will it get rejected, or will they let me correct it?

[Zim]

The guide is crystal clear... Did you read it? It's not like the form is even that complicated. Forgetting to put the name of the registering entity on the form is a pretty big screw up. They're going pretty fast right now, so you shouldn't have to wait too long to get rejected, at least.

[skt4271]

Unfortunately I found this thread about 3 hours after I submitted it

The guide is crystal clear... Did you read it? It's not like the form is even that complicated. Forgetting to put the name of the registering entity on the form is a pretty big screw up. They're going pretty fast right now, so you shouldn't have to wait too long to get rejected, at least.

[bundoc]

The guide is crystal clear... Did you read it? It's not like the form is even that complicated. Forgetting to put the name of the registering entity on the form is a pretty big screw up. They're going pretty fast right now, so you shouldn't have to wait too long to get rejected, at least.

They are going fast, received my stamp in 19 days.

[BigWaylon]

i didnt put my trust name at all, i didnt know thats where it goes. i also didnt put anything for unit of measurement. will it get rejected, or will they let me correct it?

You're probably going to need to ask to have that one cancelled and resubmit. Refund will be automatic in a couple weeks, so just go ahead and refile as soon as it's cancelled.

If you want to try one thing, you can email ted (dot) clutter (at) atf (dot) gov and see if he can correct it. I've seen at least one person get theirs corrected after it was submitted.

Resubmitting will be about as fast as waiting for a reply.

[Moose08]

Just wondering i submitted my form 1 and are the Additional Requirements boxes all supposed to be blank?(when i vewed print version) i followed the write up to the T

**** NVM I somehow missed that lil bit of info you posted about that at the end, my apologies******

[BigWaylon]

It was mentioned on the busiest slide in the guide when you got to that point. You didn't do anything wrong. Not sure if the examiner actually sees what you out there or not, but it doesn't show up on the Draft version or the Approved version.