Scar 16s (10" barrel)
Factory Trigger
Aimpoint Sight
Cheap 55 grain factory reloads from Dicks
I am getting 2 to 3 inch 3-round groups at 100 yards shooting off a rest.
Scar 16s (10" barrel)
Factory Trigger
Aimpoint Sight
Cheap 55 grain factory reloads from Dicks
I am getting 2 to 3 inch 3-round groups at 100 yards shooting off a rest.
timney trigger Mark 4 TMR Scope
100 Yard group
Last edited by SOTIC1993; 06-11-12 at 12:28.
DA - B4 1992
SOTIC 1993
getting old but can still shoot
in memory of Harvey, 5th SFG Sniper Locker
How do you like the Timney trigger?
The opinions posted above are my own and do not represent any current or former employer.
brakes and feels great, issue is the 2 screws that keep it from tilting, i do not like the way it stretches the lower at the bottom,to get rid of the bowing of the lower with the set screws I cut out some shim stock and put it between the lower and the trigger. by the way I tested the trigger it is 3.5 pounds
Last edited by SOTIC1993; 06-11-12 at 13:02.
DA - B4 1992
SOTIC 1993
getting old but can still shoot
in memory of Harvey, 5th SFG Sniper Locker
My 17S runs about 1.5 with FGMM 175 SMKs and about 2 - 2.5 with cheaper loads like WWB 147gr. Those groups were fired with a NF 2.5-10, to test accuracy, however I usually run a T1 2MOA on it and get about 2-3 MOA if i do my part.
SCAR 16S
Factory 16" 1:7 barrel w/ Battlecomp 1.0
Factory trigger w/ polished contact surfaces
PA Micro Dot (3MOA dot) + Aimpoint 3x Mag (ADM & LaRue mounts)
Federal 55gr. XM193 - 10 shot group - 3.1" @ 100 yards
PRVI/PPU 55gr. M193 - 10 shot group - 3.5" @ 100 yards (averaged across three 10 shot groups)
PRVI/PPU 69gr. HP Match - 10 shot group - 2" @ 100 yards
10 shots 100 yds. prone 168 Fed. Match NF 2.5x10x24
Early test data from the Mk318 out of SCAR barrels was pretty consistently under 1.5 MOA.
10 shot groups from machine rest. Can't remember distances, might have been both 100 and 300 yards or one or the other.
Bookmarks