That's awesome, thanks for the suggestions!
That's awesome, thanks for the suggestions!
It's something I'm looking at doing to mine, HD
The number of folks on my Full Of Shit list grows everyday
I am American
On a side note; would the IWC mount and slot micro install in other plastic components like an M4 stock?
Last edited by bookin; 05-14-12 at 14:22.
For that, you may want a cup only, unless you can figure out a way to come at it from the inside
The number of folks on my Full Of Shit list grows everyday
I am American
I was wondering about this being compatible with the sling slot on a standard M4 stock as well. The slot on the magpul handguards and the sling slot on an M4 stock seem to be very similar in size...would it work? I'm not sure what the above poster meant by "unless you can get at it from the inside"
Do not go gentle into that good night...rage, rage against the dying of the light - Dylan Thomas
I also have IWC and have been considering doing a flush model
IWC flush mount is easy to do and IMO a better option. I ran one on my rifle length MOE and also run one on my Troy Extreme rail.
For an M4 stock, this one might work better.
http://www.impactweaponscomponents.c...-mount-n-slot/
As for "unless you can get at it from the inside" I think he is referring to mounting the flush mount adapter. You have to be able to get to the other side to tighten the set screws. I used on of those in a Houge stock on my shotgun just like you would for a MOE handguard.
You might consider the Noveske QD mount. Very clever design.
Last edited by Fidalgoman; 10-08-12 at 22:00.
Bookmarks