Originally Posted by
Javon
If what your saying about the burr is true (although I have a red arrow pointing to the starting of it) not effecting it because itÂ’s on the other side then I was wrong and itÂ’s something else. However I understand what your describing about the hammer only having wear on the very top (thatÂ’s how all my other GeisseleÂ’s are too - just the normal wear from rubbing against the bottom of the Reciprocating bolt carrier - however if you look at the second photo (itÂ’s taken sideways) the wear is only on one side going from the bottom to the top (IÂ’ve never seen that before) but again, that may not be the cause of the issue (IÂ’m just guessing asking for your guys opinions). On the third photo youÂ’re absolutely right, it is off center (my other GeisseleÂ’s are all dead center). However I installed the trigger in two other striped lowers and it was the exact same off center (those two striped lowers was an Aero and a Spikes tactical). The original lower was a stripped Aero lower (with one of those PDQ buttons installed from
Aero, not me). So maybe itÂ’s gritty because itÂ’s off center (maybe a bent pin, something else - I donÂ’t know, just guessing).
It doesnÂ’t really matter, Geissele has top level customer service (everyone IÂ’ve ever talked to there is incredibly knowledgeable, kind and professional and seem eager to resolve any issue). As I said in 15 years of buying tons of their stuff NOTHING has gone wrong. IÂ’ve only ever had to call them for technical support. IÂ’m sure this trigger would work fine if I shot it, I just donÂ’t like gritty 1st stage. Anyway I sent it back so IÂ’m sure theyÂ’ll take care of it. Not worried.