I'd like to know who did the slide milling for you (since I'm in Michigan, perhaps I can avoid shipping).
Did you have any refinishing done, or did you just leave the milled portion the bare stainless?
Printable View
I'd like to know who did the slide milling for you (since I'm in Michigan, perhaps I can avoid shipping).
Did you have any refinishing done, or did you just leave the milled portion the bare stainless?
His name is Doug he is located in Taylor mi
Ill post his info tomorrow. He has done some great work on my guns
He is Doug at American Tool and Engraving.
20224 Lorne
Taylor, MI 48180
Shop: 313-388-8228
He's done a lot of work on my guns as well. I'll post picks of my Glock when I'm done stippling it...have a few others to work through first. He did FULL slide serrations, both top and sides, on the Glock. Going to have him do up my M&P as well.
Streichers is advertising a 7.0 moa red dual illumination. I was going to go with a 8.0 moa led for my G21 until I saw it. Now, I'm considering the red dual. Like you I don't see washout being an issue given my use. I'm going to give them a call to make sure it's not a misprint.
http://www.policehq.com/Products/TRJ-RM04
I didn't see this until now. I believe these are the articles you're talking about.
http://www.warriortalknews.com/2010/...stols-why.html
http://www.warriortalknews.com/2010/...ne-source.html